High quality, ratcheting torque wrench to quickly and accurately measure and apply the proper amount of torque to components and accessories.
The TW-6.2 features a dial-adjust click system to pre-set the desired torque setting.
Ratcheting 3/8 inch drive fitting.
38 cm (15 inch) length for good leverage
Ideally matched with the SBS-1 Socket and Bit set.
Protective case included for storage
Covered by Park Tool's legendary limited lifetime warranty.
Click here for tools to accompany this torque wrench.
Note - Always wind back to zero, when not in use and when setting a torque, do so from below. Therefore if going from 50 Nm, to 40Nm, undo back to 30 and then set at 40Nm.
Products & specifications shown on this website are believed to be correct, but are not guaranteed. No liability is implied or accepted. If in doubt, you are advised to confirm current specifications, before buying. At present, our stock control system is entirely manual. Whilst we endeavour to keep our records up to date, we are not infallable! Please do not rely 100% on us having an item in stock even if it says so on the website! IF YOU NEED A DEFINATE ANSWER, PLEASE CONTACT US (BUT PLEASE STATE HOW MANY OF AN ITEM YOU REQUIRE)!